Note: This message should be sent only when an initial
connection is made with the control panel. It is not
intended to be used as a ‘polling’ command. The control
panel can be programmed to send zone and system status
messages whenever the status changes with Global Programming
Location 33 – 37 in the M1 Control.
Zone Status Request
The control panel responds with a ZoneStatusReport.
Note: This message should be sent only when an initial connection is made with the control panel. It is not intended to be used as a ‘polling’ command. The control panel can be programmed to send zone and system status messages whenever the status changes with Global Programming Location 33 – 37 in the M1 Control.
4.40.5 Zone Status Request (zs)